Buy Holley 12-927 Universal In-Line Fuel PumpHolley 12-927 Universal In-Line Fuel Pump Product Description:
- For use with fuel injection systems
- Lightweight and compact design
- Flows 255 LPH at 15 PSI and draws 3.5 amps
- 3/8" barbed fittings included
- Includes rubber isolator, mounting clamps, and electrical hardware included
Product Description
This in-line fuel pump is intended for fuel injection systems and is designed to work in-line and not inside the tank. It is rated for continuous duty service and has been tested up to 2,500 hours. It should be mounted below the fuel level of the tank for a good gravity feed on the inlet side. It features a lightweight and compact design and includes 3/8'' barbed fittings, mounting clamps, rubber isolator, and electrical hardware. It flows up to 255 LPH at 15 PSI, draws 3.5-amps, and will feed up to 400 horsepower.
Customer Reviews
Most helpful customer reviews
2 of 2 people found the following review helpful.
Holley Replacement Fuel Pump
By Randolph L. Pazdur
The universal fuel pump was as described. The only dfference with this pump as compared to the stock pump that came with the fuel-injection setup that I got from Holley was the wire connector.The original was a part of the harness that "snapped" into the pump. When replacing with this pump, I did have to removed the old plug from the harness and install the supplied connectors.Other than that, it's a perfect replacement.
1 of 1 people found the following review helpful.hard to find part
By Lyle A. Barron
I had searched the net for an hour or so when I decided to go to Amazon. I found it there. I would urge others to go to amazon first to save time and money.
0 of 0 people found the following review helpful.
Holley is the BEST!!!
By Deathdeelr
So far so good!! I installed this unit last week in a custom configuration in my Grand Cherokee. I'm using it in place of the stock in-tank fuel pump and mounted this one under the frame rail along with a Fram HPG1 filter assembly. It puts out about 90psi dead headed and has no problems supplying my 4.0L straight 6 with 38psi. I've put about 500 miles on it so far with no issues.NOTE: You must find a way to waterproof the electrical connectors. The pump has a stud/eyelet type connection for the positive and negative. I ended up dousing the connectors in rubberized spray undercoating. Due to the inclement weather recently I had the opportunity (or necessity) to ford some deep water with the truck. I had no issues with the unit completely submerged (the road I needed to travel had about 4' of water at it's deepest - with the lift and tires that put the water about 6" up the door - luckily there was no water inside the truck).
Latest Price: See on Amazon.com!
More Info: See on Amazon.com!
See Customers Review: See on Amazon.com!
