Buy B & M 70298 Hi-Tek SuperCooler Oil Cooler with FanB & M 70298 Hi-Tek SuperCooler Oil Cooler with Fan Product Description:
- Adds additional cooling capacity for engine oil or automatic transmission fluid -- keeping these systems in the right operating temperature range increases reliability and durability
- Black finished fin and plate construction includes 1/2 NPT fittings and 175 degree thermal switch
- Also includes high flow 7" diameter 12 volt fan that pulls 6 amps and 350 cubic feet per minute
- Sized 10" by 7-1/2" by 4", and pressure tested to 200 psi
- Backed by the manufacturer with a 1 year limited warranty
Product Description
Keeping your engine and transmission in the right temperature range is critical, and B&M's Hi-Tek cooling system can help you do it. Each unit works equally well as either an engine oil or transmission fluid cooler, so add it into the system that concerns you the most, or get two to cover them both. The cooler is constructed using a fin and plate design with a black finish, and includes 1/2 NPT fittings and a thermal switch that turns on the electric fan at 175 degrees Fahrenheit. The 7 inch diameter 12 volt fan has built in mounting brackets for easy attachment to the cooler, and is rated at 350 CFM at 6 amps.
Customer Reviews
Most helpful customer reviews
8 of 8 people found the following review helpful.
Quality Product and great customer service
By J. Sears
This product preforms as advertised and is easy to install. Received item in 2 days with standard shipping. After installing the cooler it became apparent that part of the wiring harness was missing. I notified Amazon and their response exceeded my expectations. Rather than require me to remove the unit I had already installed they overnighted a compete replacement unit and issued a call tag to return the parts I didn't need. After this experience I will purchase from Amazon even if their price is a little higher. I don't mind paying extra for great service.
4 of 4 people found the following review helpful.Great cooler
By kbono79
Installed this on a 2007 Chevy 1500 to help the trans out when the camper hooked up.Last year with out it the trans ran around 200F this year 160F to 170F.Much bigger than the sock cooler but very easy to install just make a couple of brackets and wire it in 2 hour it was installed.Very happy with it so far
3 of 4 people found the following review helpful.
B&M 70298 Hi-Tek SuperCooler Oil Cooler with Fan
By lw
Fan/cooler is a stout, high quality unit. Unfortunately, it is a lot bigger than the dimensions listed on Amazon or B&M's site .They indicate 10" wide X 7-1/2" high, it actually measures 10" X 9-1/4". The cooler itself measures 7" high, without the inlet/outlet, mounting brackets or temperature sensor. The temp sensor's plug and wire adds another 1/4"-1/2", depending on how tightly you want to bend the wire. That makes it 2"+ higher than advertised.Too bad it is so much taller, it will not fit my application. Looking into this a little deeper, I can build a fan and cooler, that will actually fit, using off the shelf parts, for less money.
Latest Price: See on Amazon.com!
More Info: See on Amazon.com!
See Customers Review: See on Amazon.com!
